Underwater Marine Lights

Bullet Lines' Underwater Marine Lights. 6 x bulb LEDs in water proof stainless steel casing. Our underwater boat LEDs are super bright, and will light up to 30' of water (depending on water clarity) behind your boat in 180 degrees. These LED lights were designed by Bullet Lines to out perform all other brands in brightness (Lumens), power consumption, heat, and ease of installation. LEDs mount to the rear wall (transom)of your boat under water, and come in your choice of white, blue, or red.

Features

· Lights up to 30' of water.

· Water proof 316 stainless steel casing

· Easy installation.

· Low power consumption

· Lumens: 360

· Voltage: DC 12V

· Power: 6W

· Peak Angle: 180 degrees

Purchase Bullet Lines' underwater marine lights below:

http://www.krypt-wakeboard-towers.com/servlet/the-90/Underwater-Marine-Lights--dsh-/Detail

What to Look for in an Underwater Marine Light

Underwater boat lights can be used for accenting light, fishing light, and scuba diving light. These underwater lights have evolved over the years becoming much more energy efficient, brighter, and cost effective. Since clarity of the water directly affects brightness, you should be sure what your local waterways clarity is before purchasing. As boating has increased in popularity, underwater marine light manufacturers have honed more efficient designs, discovered the best materials, and created some great options for your boating needs.

• Custom Made Underwater Marine Lights

When searching for your underwater lights you will need to decide between a custom made light and a manufactured light. One advantage of a custom wakeboard tower is that no adjustment will be required since it will be created to the exact specifications of your boat. Also, a custom underwater light can be made to your exact specifications . There are two potential downsides to a custom underwater marine light. The first is that you can expect your underwater light to take anywhere from one to five weeks to be made. Secondly, the price of any thing is higher when it is specially designed, and this is the case with a custom underwater marine LED.

• Manufactured Underwater Marine Light

Manufactured Underwater Marine Lights are by far the most efficient way to go.. These lights are usually mass produced, so the benefit is a better product cheaper. Manufactured lights are usually cheaper and made with better quality materials. We of course recommend using Bullet Lines Underwater Marine Lights, as they are the brightest LED for the money.

• Installation of underwater marine lights

Important – For Safety LED Should Be Installed by a Professional – Must be installed under water line, and only used when submerged – Be sure inside of hull is free and clear in the mounting area before drilling – Countersink all drilled holes to avoid gel coat cracking.

Do not drive with LEDs on unless you check with your local, state, and federal waterway laws first.

Center Hole: Use ½” drill bit and drill ¼” ( don't drill all the way through fiberglass ) deep: in the center of your hole drill all the way through your transom with a 3/16” drill bit.. Push LED wire through hole, hold LED flat against surface and mark mounting holes through eyelets . Mounting holes : Use 1/8” drill bit and drill ½” ( don't drill all the way through fiberglass ) deep.

Fill up all countersink and screw holes with a quality marine grade underwater sealant.

Take LED and slide wire through center hole all the way into hull of boat. Make a ¼” bead of sealant tight around wire inside and outside of hull. Slowly push LED into position over mounting holes and slowly tighten mounting screws in holes.

Electrical connection: Attach provided inline fuse to red positive wire, and then attach positive wire to positive connection. Attach other color wire to a negative connection. Be sure positive connection is equipped with 2 amp circuit protection and that voltage is not higher than DC12.5V. Voltage with the boat engine on will be higher than 12.5v, the LEDs will be brighter, but the higher voltage will lower life expectancy of the LEDs. You can choose to add a simple voltage regulator if you are concerened.